Table of Contents
Advertisement
3 Operation
Fig. 3-14. Load Tape on Reel
Fig. 3-15. Install Tape Thru Rollers
Fig. 3-16. Attach Tape to Heat Applying Roller
as Shown
3- -10
CAUTION: When stringing the Heat Seal Tape,
care must be taken to twist the tape in the
correct manner so that the adhesive is facing
away from the strip- applying roller and that the
raw polyester is against it.
The polyester tape is on 3" cores.
Step: 1. Place the reel of tape on the reel holder.
Step: 2. You may use a small piece of
self--adhesive tape to fasten the end of
the polyester tape to the applying roller.
Step: 3. Interweave the end of the strip of tape
around the rollers over the top of the
machine and under the guide pins to the
"applying roller" as shown in Fig. 3-15. &
Fig. 3-16. .
Edge Reinforcer Issue 1
Advertisement
Table of Contents
