Scott Edge Reinforcer Instruction Manual page 46

3 Operation
C
Fig. 3-49. Attach Tape End to Heat Roller (Heat
Should be Off)
3- -26
D
B
A
Step: 7. The tape (A) should be coming off of
bottom of the roll so that the adhesive
side is facing out.
Step: 8. Loop the tape over roller and stick the
end of the tape to the Heat Roller (B).
NOTE: The Heat must be off.
Step: 9. Run 2--3 sheets of stock and discard
them so that the finger prints are not
showing through the tape on the
processed sheets.
Step: 10.Loosen the set screws in the collars (C &
D) to adjust the location on the paper
where the tape is being applied.
Edge Reinforcer Issue 1