Changing From Heavy Stocks To Light Weight Paper Stocks 3 - Scott Edge Reinforcer Instruction Manual

3 Operation
3.3.11 Changing From Heavy Stocks To Light Weight Paper Stocks
Before shipping from the factory, all machines are tested by reinforcing 20# bond paper at full speed.
Note !
The machine will not reinforce lighter than 20# bond paper.
Because lighter weight papers are more difficult to reinforce and cut accurately, it might be necessary to slow
down the machine at times. The ability of the "cut--off guide finger" to accurately gauge the cutting is affected
by the rigidity of the paper. Since some papers of the same weight vary in rigidity, it is not possible to predict
the exact operating speed.
Fig. 3-38. Loosen Drive Motor Mounting Bolts
Fig. 3-39. Loosen Set Screw in Pulley Hub
3- -20
If it is ever necessary to slow down the machine,
the following is done:
Step: 1. Loosen the drive motor mounting screws
and slide it toward the rear of the
machine (discharge end) so that the
pulley can be adjusted.
Step: 2. Loosen the set screw in the hub of the
outer flange of the pulley.
Edge Reinforcer Issue 1