Table of Contents
Advertisement
3 Operation
Fig. 3-24. Run Sample Sheets - - Measure Cut
Fig. 3-25. Loosen Guide Finger Set Screw
Fig. 3-26. Rotate Guide Finger Assembly
Dimension of Cut
3- -14
3.3.6
Testing the Cut Off Guide
Finger
When changing stocks it is sometimes necessary
to adjust the Cut Off Guide Finger.
To Test:
Step: 1. Run 3--5 sample sheets of stock.
Step: 2. Determine if the cut off guide finger is
cutting into the either the leading or the
trailing edge of the stock.
Step: 3. If there are cuts in the stock as shown in
Fig. 3-24. , measure the distance from
the edge of the sheet to the edge of the
cut. This will determine how much Cut
Off Guide FInger adjustment is
necessary.
Step: 4. Loosen set screw securing guide finger in
place.
Step: 5. Hold on to knife housing assembly while
rotating guide. Rotate guide finger the
approximate dimension that the cutter is
cutting into the paper edge.
Example: If the guide finger is cutting into the
leading edge of the paper 1/16th" then rotate the
guide finger 1/16th" clockwise.
Rotate the guide finger clockwise to adjust
leading edge dimension.
Rotate guide finger counterclockwise to adjust
trailing edge dimension.
Step: 6. Tighten set screw.
NOTE!
Do Not Over tighten.
Step: 7. Test by running 3--5 more sheets.
Step: 8. Repeat until there is no cut on either
paper edge.
Edge Reinforcer Issue 1
Advertisement
Table of Contents
