Scott Edge Reinforcer Instruction Manual page 27

Fig. 3-5. Stop Push Button
Fig. 3-6. Feed ON/OFF Illuminated Push Button
Fig. 3-7. Drive Mode Selector Switch
Edge Reinforcer Issue 1
3.2.2.4 STOP - - Red Pushbutton
The pushbutton stops the machine drive. This is a
"soft" stop and is intended for planned stops, not
emergencies.
To reset after a stop, the button must be pushed
again so that the button is extended out.
3.2.2.5 Feed ON/OFF Illuminated Push Button
Pushing this button starts the conveyor drive motor
so that when sheets are hand fed, they will be
drawn into the machine.
The button will be illuminated when the feed in ON.
3.2.2.6 Drive Mode Selector Switch
The Drive Mode Selector switch controls the drive
motor for the brake clutch which makes the heat
roller and cut off package operate.
JOG -- Used during maintenance and tape set up.
This is a manual override of the trip switch. The
conveyor must be running.
OFF -- Turns the drive conveyor off.
ON -- This is the normal production setting. The
Feed Button must also be turned on. When the
switch is in the ON position, the trip switch is
activated which, when a sheet is present, activates
the clutch to rotate one revolution to draw in one
sheet.
3 Operation
3- -7