Table of Contents
Advertisement
3 Operation
Fig. 3-42. Feed One Sheet at a Time
Fig. 3-43. Clutch Light Should Turn Off Between
Sheets
3- -22
3.3.12 Tips For Feeding Lightweight
Stocks
Because of the lack of rigidity in light--weight
stocks, more care must be taken in feeding paper.
Step: 1. Check the corners of the sheets to make
certain they are not damaged or bent.
NOTE!
Sheets with bent corners tend to jam
machine.
Step: 2. The machine should be fed with
particular care. When feeding lightweight
stocks, care should be taken to keep the
sheet against the left--hand side guide so
the sheets get started into the machine
straight. A SHEET FED CROOKED WILL
TEND TO HAVE ITS CORNER
DAMAGED WHEN THE TAPE PULLS IT
AGAINST THE LEFT--HAND SIDE
GUIDE, and a bend will jam the machine.
NOTE!
Do not feed too fast. It is important
that while feeding sheets, the clutch
light turns off between each sheet.
This should be done for heavy sheets
also, but the problems are magnified
on light stocks.
Edge Reinforcer Issue 1
Advertisement
Table of Contents
