Adjusting Tape Position On Paper 3 - Scott Edge Reinforcer Instruction Manual

3 Operation
Fig. 3-20. Tape Position Adjustments
Fig. 3-21. Insert Spring Loaded Pins in to
Mounting Holes
Fig. 3-22. Adjust for Paper Size
3- -12
3.3.3
G
There are two parts on the machine which
determine the distance the tape is applied from the
edge of the sheet:
D
Cross Over Bar (G) - - This guides the tape over
the top of the machine. This bar is mounted to the
gear box housing by two hand knobs. Loosening
the knobs will allow the bar to be moved back and
forth so that the position where the tape comes
down in front of the machine may be adjusted.
Tape Position Roller (D) - - The roller is mounted
on the guide spindle on the front of the machine
directly below the "cross--over arm". By adjusting
this collar back and forth on its spindle, the tape
can be controlled so that it will be applied in the
correct position on the paper.
3.3.4
The delivery tray may be adjusted for long or short
sheets. The tray is mounted on two spring--loaded
pins. To remove or change the position of the tray,
push the tray sideways and tilt so that the pins
come out of their sockets. You will see several
sockets in the main frame for different positions.
Step: 1. The sides of the paper tray should be set
Step: 2. Taper the side of the adjustable tray
Adjusting Tape Position On
Paper
Adjusting Delivery Tray
up according to paper size. The
adjustment knobs are located on the
underside of the paper tray.
slightly toward the leading edge of the
paper.
Edge Reinforcer Issue 1