Infineon iMOTION EVAL-M1-05-65D User Manual page 8

EVAL-M1-05-65D User Manual
iMOTION™ Modular Application Design Kit
Main features
Table 4 shows the important specifications of the evaluation board EVAL-M1-05-65D.
Table 4 EVAL-M1-05-65D board specifications
Parameters
Input
Voltage
Frequency
Input current
Output
Power (3phases)
Current per leg
DC Bus
Maximum DC bus voltage
Minimum DC bus voltage
Current feedback
Current sensing devices
RS1, RS2, RS3
Protections
Output current trip level
On board power supply
15 V
3.3 V
PCB characteristics
Material
Dimension
System environment
Ambient temperature
User Manual
Value
100-240 V
rms
50/60 Hz
1.5 A
rms
90 W**
650 mA*
rms, f =6 kHz, T =25°C, **input 220V
*
PWM a
400 V
110 V
0.25 Ω
2.5A
pk
15 V±5 %, Max 20 mA
3.3 V±5 %, Max 50 mA
FR4, 1.6 mm thickness,
2-layers. 35 µm copper
thickness
90 mm x 75 mm
From 0 to 70°C
8
Conditions
IRSM505-065DA/ IRSM515-065DA,
module T = 70°C without heatsink
c
IRSM505-065DA/ IRSM515-065DA
IRSM505-065DA/ IRSM515-065DA
, T =125°C, */**without heatsink
AC c
The default configuration uses three shunts in
the emitter paths. To implement single shunt
sensing, the board should be modified:
1) RS1 and RS3 have to be removed
2) IU+,IV+,IW+ have to be connected
3) R7 has to be changed to 3.48 kΩ
Configured by either changing shunt resistors
RS1, RS2, RS3 or adapting comparator
threshold changing resistor R7
Used for CIPOS™ Micro gate driver power
Used for interface signals to the control board
and alarm signals as I
TRIP
Non-condensing, maximum RH of 95 %
, FLT/EN
Revision 2.1
2018-07-09