Installation; Console Installation - E-max BingoConsole Operator's Manual

2.0 Installation

Required Tools
1. 3/16 inch Allen wrench
2. ¼ Socket Driver (torque)
3. 5/16 Socket
4. Socket Extension 4"

2.1 Console Installation

Roll both (or all three) cabinets into the approximate place they will be used.
Ideally you would like the console to be slightly elevated and centered in the hall. Position the two cabinets
as close together as you can with the Ball Blower on the side selected by the hall manager, or place the
electronics console in between the two ball consoles.
Slide the first aluminum U channel between the cabinets along the bottom. Use eight of the 5/16" – 18 x ¾"
bolts and washers to secure the bottom and sides of the two cabinets together (AT THIS POINT DO NOT
TIGHTEN BOLTS COMPLETELY WHICH WILL PREVENT PROPER U CHANNEL ALIGNMENT).
Next, install the top aluminum U channel using the same method described above. Next, Run the Ball tray
computer, USB and ball chamber power cables through the holes provided, into the Electronics cabinet.
(Refer to Section 2.4 for electrical installation procedures) Lastly, torque each bolt to between fifteen and
twenty foot pounds to secure U Channel's in place.
Unlock the Electronics Cabinet drawer and open about one inch. Unlock and open the Graphics Panel door
on the Electronics cabinet. Using access provided by the graphics panel door, feed the three cables from the
Ball Blower Cabinet into the Electronics Cabinet. Insert the front Filler Panel between the cabinets in front of
the console (IF TWO BALL CONSOLES ARE PRESENT FEED SECOND GROUP OF THREE CABLES
FROM SECOND BALL CONSOLE INTO ELECTROICS CONSOLE). Attach the rubber bungee cord to
the eye hook. Next attach the other end of the rubber bungee cord to the rear Filler panel. (Note: Ensure
that the cup holder is facing up) (Figure 2.1)
Open the set of Atlas bingo balls. The E-max Gaming Corporation recommends ONLY Atlas bingo balls.
Atlas bingo balls are multi-colored and double numbered. Other balls may have been specified for your
system. Inspect each ball for damage and insert each ball into its corresponding slot in the ball tray to ensure
the set is complete. Any problems,
contact your distributor for a
replacement.
Figure 2.1
E-max Gaming Corporation, Inc.
9
2
Chapter