Electrical Installation - E-max BingoConsole Operator's Manual

Black Ball
Release
Knob

2.4 Electrical Installation

Refer to Appendix A for Diagrams
Connect three cables from the ball console to electronics console:
1. Plug ball console AC power cord into blower #1 socket on outlet strip #2
(Figure 2.5). If present, plug second ball console AC cord into blower #2 socket on outlet strip #2.
2. Plug in communications cable to the data router BT1 connector. Plug second communications cable into BT2.
3. Plug in camera cable into Dell computer USB5 connector. Plug in second camera into Dell USB1 connector.
NOTE: If you are installing a double blower configuration, you must configure the CPU for two ball chambers.
Refer to section 11.10 for hardware setting procedure.
CONNECT UPS TO POWER SOURCE:
The main AC power input to the E-max
TM
cord to the E-max Bingo Console should be wired with 12AWG or 14AWG with ground. The AC power input
circuit must be rated for at least 15A and no other hall equipment should share this power source. Do not run long
extension cords with inadequate wire gauge from the power source to the console.
CAUTION! A POWER SOURCE WITH ABNORMAL VOLTAGE OR EXCESSIVE NOISE CAN
RESULT IN IMPROPER CONSOLE OPERATION AND POSSIBLE DAMAGE NOT COVERED
UNDER WARRANTY.
1. Plug the cord from console Outlet Strip #2 (on the operator side of the electronics console) into the main
power source.
Ball
Tube
Ball Camera
with light
FIGURE 2.4
TM
Bingo Console should be 115VAC, 60Hz. The power outlet or power
E-max Gaming Corporation, Inc.
Red Door
Release
Knob
12
Black Ball Release
Knob