E-max BingoConsole Operator's Manual page 46

System Power Issues:
Problem
Electronics and Ball
consoles have no power
Power available, but
Electronics console
equipment not powered
correctly
Power available, but Ball
console equipment not
powered correctly
UPS did not work properly
when AC power failed
UPS is beeping
Possible Cause
Hall power not available
Outlet strip #2 power cord
not plugged into hall power
or outlet switch not on
UPS power switch not ON
UPS circuit breaker tripped
Dell AC cord unplugged
from UPS
Dell computer turned off
Operator Monitor AC cord
unplugged from UPS
Operator Monitor turned off Depress Monitor ON switch
AC Outlet Strip 1 not
plugged into UPS
AC Outlet Strip 1 or 2
circuit breaker tripped
AC power cord to Ball
console not plugged into
Electronics console
Blower motor unplugged or
blower motor circuit
breaker tripped
Blower motor switch OFF
UPS defective or battery
pack worn or defective
Low AC line voltage
E-max Gaming Corporation, Inc.
46
What to do or check
Check hall fuses or circuit
breakers
Plug cord into 120 VAC,
grounded power source
Depress power ON switch
Depress UPS circuit breaker
button on the back of the
UPS
Plug in Dell power cord to
UPS1 socket as shown in
the Appendix
Depress power ON button
on Dell computer
Plug in Operator Monitor
AC cord to UPS2 socket as
shown in the Appendix
on the front panel of the
monitor
Plug strip into UPS as
shown in the Appendix.
Note that strip 1 must go
into UPS3 socket.
Reset outlet power switch to
ON position
Plug in power cord to
Outlet strip #2 socket as
shown in the Appendix
Inside the blower motor
compartment, check that the
AC power cord is plugged
into the outlet. Reset the
breaker switch on the outlet
Place the switch on the ball
tray to the ON position
Call for service to replace
the UPS
Specification in Appendix