Servicing & Cleaning - E-max BingoConsole Operator's Manual

8
Chapter
8.0 Servicing and Cleaning
8.1 General Cleaning of Your E-
max Bingo Console
TM
Periodic servicing of your bingo equipment should include cleaning, polishing,
and light bulb replacement. Doing so will prolong the life of the equipment, increase trade in value, and reduce
breakdowns. Recommended cleaning agents and methods for the console and flashboard are as follows:
Monitor Touch Screen
Pour rubbing alcohol on a clean soft cloth and gently rub the screen to remove greasy finger prints. CAUTION:
Do not pour alcohol, water or any other liquid directly on the screen.
Console Painted Metal Surface
Use a mild soap solution or mild cleanser on a soft cloth. Harsh cleansers or solvents may damage the paint or
lettering. Follow with an automotive style polish for additional protection. CAUTION: Do not pour alcohol,
water or any other liquid directly on the surface.
Console Laminate Panels
Use a mild soap solution or Kitchen style cleaner on a soft cloth. Harsh cleaners or solvents may damage the
laminate surface.
Console and Flashboard Acrylic Surfaces
Use only a mild soap solution such as a liquid detergent solution on a clean soft cloth. Do not use solvents,
aromatic spirits, mild cleansers or paper towels since they may scratch the surface. CAUTION: Do not pour
alcohol, water or any other liquid directly on the surface.
Camera Lens
Use a vacuum cleaner to remove major dust and debris. Use a soft cloth to wipe lens.
Bingo Balls
Clean with a soft cloth and mild soap solution such as a liquid detergent and warm water (not hot water) or a
solution of 25% rubbing alcohol and 75% warm water. Harsh cleansers or solvents may damage the finish or
lettering. Dry the balls thoroughly using a cloth towel. Do not submerge the balls in liquids or use automatic
washing machines.
8.2 Replacing the Graphics Panel Lamp
HARZARD! Before replacing the light, turn off the switch on outlet strip #1.
The Graphics Panel fluorescent light is located just inside the electronic console above the graphics panel door.
Remove the Light fixture from the console and gently squeeze the diffuser lens to remove it from the fixture. The
fluorescent lamp should be replaced with the lamp specified in Appendix B.
E-max Gaming Corporation, Inc.
43