3.3 Resetting the Ball
If the ball was inserted in the wrong hole then:
•
Remove the ball from the hole
•
On the operator monitor, touch the ball number of the wrong hole. This will reset the ball and the system
will be updated.
•
Insert the ball in the proper hole and depress it to active the switch. The system is updated and correct.
3.4 Ball Tray System Failure
If the ball tray switches stop working, the ball should still be placed in its proper hole. The ball can be "called"
by touching the ball number on the operator monitor. The system will be properly updated.
3.5 Manual Mode
1. In the event of the Dell computer fails and the operator monitor is not operational, there is a system
Manual Mode that allows for only fundamental bingo operations.
2. The console is designed to automatically detect a Dell failure and switch to Manual Mode. This results in
the two red LEDs on the Flashboard Reset switch and Ball Reset switch to turn on. These two switches
now become active.
3.6 "Calling" a Ball in Manual Mode
1. To "call" the ball, remove the ball from the ball tube and insert the ball into its corresponding numbered
hole in the ball tray.
2. Momentarily depress the ball to activate the switch associated with that ball.
3. The Flashboard will be updated.
3.7 Resetting a Ball in Manual Mode
If the ball was inserted in the wrong hole then:
•
Remove the ball from the hole
•
Hold down the switch in the wrong hole and then momentarily depress the Ball Reset switch.
•
Release the switch in the wrong hole.
3.8 Resetting the Flashboard in Manual Mode
To advance to the next game:
•
Hold the Flashboard Reset switch down for at least 2 seconds until the flashboards clear.
• All of the individual ball switches are now active again for calling new balls. All previous ball
information is lost.
E-max Gaming Corporation, Inc.
16