Getting Started; Unpacking - E-max BingoConsole Operator's Manual

1.0 Getting Started

TM
The E-max Bingo Console was designed to have a distinctively attractive
appearance, using careful manufacturing and assembly techniques to insure
TM
quality. The E-max Bingo Console is modular in design comprising of an
electronics console and a ball console. Each is packaged in a separate shipping
container. One system configuration uses two ball consoles with one electronic
console. In this case, you will receive three shipping containers. Each Ball
Console weighs approximately 165 pounds while the Electronics Console weighs
about 196 pounds.
1.1 Unpacking Console
Inspect the shipping containers for possible signs of damage. If damage is detected, refer to the Damage
Action Process section (1.3) for procedures.
Use scissors or box cutter to cut the straps from the skid only, taking care not to cut the straps protecting the
console. With the help of at least one assistant, carefully slide the Ball Blower Section of the console from
the skid and place it on solid flooring. Cut the remaining four straps from the console and remove the
cardboard top.
Remove the foam packing inserts from inside the top and slide the cardboard tube up and off the console. A
minimum of two people are required to safely unpack the console. Never lift the Ball Blower section by the
arm rest or any part of the ball chamber or ball catcher assembly (lift only by the console top). With one
person lifting from each end of the console, raise the console up and out from the carton and foam inserts. Set
the unpacked Ball Blower section on solid flooring. Check that all casters are in place. Do not destroy or
discard carton or packing material until after final inspection and testing.
Next, carefully slide the Electronics cabinet carton from the skid. Cut the remaining four straps from the
carton and remove the cardboard top. Remove the foam packing inserts from inside the top and slide the
cardboard tube up and off the console. A minimum of two people are required to safely unpack the console.
Never lift the Electronics cabinet from the monitor arm or any part of the monitor. Ensure that all doors and
drawers are secure before lifting. With one person lifting from each end of the Electronics cabinet, raise the
console up and out from the carton and foam inserts. Set the unpacked electronics Cabinet section on solid
flooring. Check that all casters are in place. Do not destroy or discard carton or packing material until after
final inspection and testing.
Unpack the keyboard from the cardboard box. Place the keyboard on the electronics cabinet in front of the
touch screen monitor. Remove the mouse from the plastic bag and set next to the keyboard.
At this point, you should inspect the consoles for any obvious shipping damage. If any problems are found,
immediately contact your distributor for advice and refer to the Damage Action Process section (1.3) for
procedures.
E-max Gaming Corporation, Inc.
7
1
Chapter