E-max BingoConsole Operator's Manual page 49

Electronics Console Issues (continued):
Problem
Printer (optional equipment)
VCR (optional equipment)
Ball Console Issues:
Problem
Blower motor
Poor bingo ball action
None of the ball tray switches
work
One or a few of the ball tray
switches do not work
Possible Cause
AC power cord unplugged
Communications cable
unplugged
Print quality, ink cartridge
Defective equipment
AC power cord unplugged
Video cable unplugged
Defective equipment
Possible Cause
No AC power, On/Off switch,
circuit breaker tripped
Clogged blower air filter
Low line voltage
Excessive static
Lid on inner ball chamber
misaligned
Defective blower motor
Data Router or Ball Tray
software
Communications cable
unplugged
Defective Ball Tray
Defective Data Router
Defective Ball Tray
E-max Gaming Corporation, Inc.
49
What to do or check
Plug in power cord to Outlet
strip as shown in Appendix
Plug in cable to Dell and/or
Printer as shown in Appendix
Replace cartridge
Call for service
Plug in power cord to Outlet
strip as shown in Appendix
Plug in cable as shown in
Appendix
Call for service
What to do or check
Check procedures under
System Power
troubleshooting
Replace filter
Specification in Appendix
Make sure anti-static band is
installed in the bottom of the
ball chamber. If it is installed,
call for service
Check for proper seating of the
lid and that ball extraction tube
is centered over blower hole
Call for service
Depress Reset switch on the
front of the Data Router
Plug in Ball Tray cable to Data
Router as shown in Appendix
Call for service. In the
meantime, use the touch panel
on the Operator Monitor to call
and reset balls
Call for service
Call for service. In the
meantime, use the touch panel
on the Operator Monitor to call
and reset balls