Battery And Charge Information; Replace The Battery; Battery Recommendations - Honeywell 8680i User Manual

Battery and Charge Information

The battery must be fully charged before the first use. An MB4/MB12-BAT-SCN02
or an MB4/MB12-SCN02 Charging Station must be purchased separately.

Replace the Battery

When the battery is low, the 8680i beeps and vibrates and the window shows a Bat-
tery Low warning. You can also press both the right and left buttons at any time to
view the battery's charge status.
Note: The battery should be replaced in an environment free from excessive dust or
particulate to avoid an internal buildup of dust in the unit.
To replace the battery, squeeze the battery latch and lift up on the battery.
Replace the battery by snapping it in to the 8680i.
The BAT-SCN02 high capacity lithium ion battery or the BAT-SCN03 standard
capacity lithium ion battery can be used. Batteries are not fully charged when
shipped. The battery should be charged for a minimum of 4 hours before initial use
to ensure optimal performance.
Caution: There is a danger of explosion if the batteries are incorrectly

Battery Recommendations

•
8680i User Guide
replaced. Use only Honeywell lithium ion battery packs, model
numbers BAT-SCN02 or BAT-SCN03 in this device. Use of any
non-Honeywell battery may result in damage not covered by
the warranty. Dispose of used batteries according to the recycle
program for batteries as directed by the governing agency for
the country where the batteries are to be discarded.
The battery is a lithium ion cell that can be used without a full charge and can
also be charged without fully discharging without impacting the battery life.
7