Keyboard Modifiers; Preferred Symbology - Honeywell 8680i User Manual

Keyboard Modifiers

This modifies special keyboard features, such as CTRL+ ASCII codes and Turbo
Mode.
Control + X (Control + ASCII) Mode On: The scanner sends key combinations for
ASCII control characters for values 00-1F. Windows is the preferred mode. All key-
board country codes are supported. DOS mode is a legacy mode, and it does not
support all keyboard country codes. New users should use the Windows mode.
Refer to
Windows Mode Prefix/Suffix Off: The scanner sends key combinations for ASCII
control characters for values 00-1F, but it does not translate prefix or suffix infor-
mation.
Default = Control + X Mode Off.
DOS Mode Control + X Mode On

Preferred Symbology

The 8680i can be programmed to specify one symbology as a higher priority over
other symbologies in situations where both bar code symbologies appear on the
same label, but the lower priority symbology cannot be disabled.
8680i User Guide
ASCII Conversion Chart (Code Page
Windows Mode Control + X
Mode On
1252), page 224 for CTRL+ X Values.
* Control + X Mode Off
Windows Mode Prefix/Suffix
4 Characters
53