Battery Part Numbers; Charge The Battery Before Use - Honeywell ScanPal EDA51 Series User Manual

For a list of compatible accessories for the EDA51 mobile computer series and
their part numbers, see the ScanPal EDA50/EDA51 Accessory Guide, available for
download from the EDA51 product page at sps.honeywell.com. Contact your local
sales representative for replacement battery ordering information.
Caution: Improper battery replacement or incompatible device usage may

Battery Part Numbers

Caution: Read
Battery Model Number
BAT-EDA50

Charge the Battery Before Use

ScanPal EDA51 computers ship with the battery significantly discharged of power.
Fully charge the battery before using your computer for the first time.
You can charge the battery with a ScanPal EDA50/EDA51 series charging
accessory before or after you install the battery in the computer. A fully discharged
battery charges in approximately 4.5 hours.
To charge the battery before you install it in the computer:
•
To charge the battery after installing it in the computer:
•
Note: Using the computer while charging the battery increases the time required to reach
a full charge.
EDA51 User Guide
result in risk of burns, fire, explosion, or other hazard. Dispose of
lithium-ion batteries according to local regulations. Risk of fire and
burns if improperly handled. Do not open, crush, heat above 60°C
(140°F), or incinerate.
Battery Recommendations and Safety Protections
and all cautionary markings on the battery, charging peripheral, and
device using the battery before attempting to install, use, or charge
the battery.
Insert the battery into the EDA50/EDA51 Quad Battery Charger (EDA50-QBC)
or the auxiliary battery well of a EDA51 Single Charging Dock (EDA51-HB)
connected to a power source.
Insert the computer into a EDA50/EDA51 Single Charging Dock (EDA50-HB/
EDA51-HB) or Quad Bay Charging Base (EDA50-CB) connected to a power
source.
Battery Part Numbers
50129589-001
50134176-001 (For use in North America)
on page 11
5