Intercharacter Delay; User Specified Intercharacter Delay - Honeywell 8680i User Manual

Intercharacter Delay

An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed between the transmission of each character of scanned data. Scan the
Intercharacter Delay bar code below, then scan the number of 5ms delays, and
the Save bar code from the
To remove this delay, scan the Intercharacter Delay bar code, then set the number
of delays to 0. Scan the Save bar code from the
page 235.
Note: Intercharacter delays are not supported in USB serial emulation.

User Specified Intercharacter Delay

An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed after the transmission of a particular character of scanned data. Scan the
Delay Length bar code below, then scan the number of 5ms delays, and the Save
bar code from the
Next, scan the Character to Trigger Delay bar code, then the 2-digit hex value for a
printable character to trigger the delay (see
225.
To remove this delay, scan the Delay Length bar code, and set the number of
delays to 0. Scan the Save bar code from the
page 235.
8680i User Guide
Programming Chart,
)
Delay Length
Programming Chart,
Prefix Scanned Data
1 2 3 4
Intercharacter Delay
Intercharacter Delay
beginning on page 235.
Lower ASCII Reference
Programming Chart,
beginning on page 235.
Suffix
5
Programming Chart,
Character to Trigger Delay
beginning on
beginning on
Table, page
71