Table of Contents
Advertisement
Safety Precautions (Continued)
PRECAUTIONS REGARDING MAINTENANCE,
INSPECTION, AND PARTS REPLACEMENT
■ Be sure to set the power switch on
the equipment to the OFF position
before doing maintenance or inspection
inside the equipment or replacing its
DO
parts.
Failure to observe this can cause
electric shock or equipment failure.
■ Do not touch the terminal block
during maintenance or inspection. If it is
necessary to touch the terminal block,
set the power switch on the equipment
DON'T
to the OFF position in advance.
Failure to observe this can cause
electric shock.
■ Do not touch the detector main body
during measuring fluid density.
The temperature of the detector main
DON'T
body rises with fluid temperature.
Touching the detector main body
causes burns.
WARNING
Yellow
DON'T
6
■ Be sure to set the power switch on the
equipment to the OFF position before
replacing the fuse.
DO
Failure to observe this can cause electric
shock.
■ Do not attempt disassemble or modify
the equipment.
Failure to observe this can cause electric
shock or equipment failure.
The label shown at left is placed near
each terminal block on the equipment
to which power is supplied. Be careful
of electric shock.
6 F 8 A 0 7 8 7
Advertisement
Table of Contents
