Mechanism Adjustment - Yamaha YTZ250S 1986 Service Manual

3. Install the clutch housing and washer.
1. Washer
4. When installing the clutch locknut, always
use a new lock washer. After tightening
the locknut to the specification, be sure
to lock it with the lock washer.
Clutch locknut torque:
75 Nm (7.5 m.kg, 54 ft·lb)
5. When installing the clutch pressure plate,
align arrow mark on clutch boss and
pressure plate mark.
6. Tighten the drive gear nut.
3-24
Primary drive gear nut torque:
115 Nm (11.5 m.kg, 85 ft·lb)
Mechanism Adjustment
1. Disconnect the clutch cable at push lever
end.
2. Turn the push lever to align the push lever
with the crankcase edge.
Align the edge of push lever to the
crankcase edge.
3. Loosen the short push rod locknut and
turn the short push rod in or out until it
lightly seats against a push rod ball.
Tighten the locknut.
4. Connect the clutch cable and install the
right crankcase cover, kick crank, and
footrest.
5. Connect the coolant hose and fill the
collant.
6. Add oil through the oil filler hole.