Yamaha YTZ250S 1986 Service Manual page 143

cr>
....,.
<.0
Throttle cable
Route on left side of frame and over
radiator guard pipe, and between engine
mounting plates.
Make sure this portion is not in contact
with the top of the radiator or COl unit.
Route on the right side of the radiator (Ll
and under the COl unit.
Brake hose
U
Thermostatic valve
Clutch cable
Bring upward from case and pass
through clamp on manifold, then to right
side of frame.
Breather
Left side of frame -+ over radiator guard
and pipe -+ between engine mounting
plates -+ right side of throttle cable -+ clamp
(outside of case breathed on carburetor
joint -+ recovery tank.
No excess slack in pipe between clamp
and recovery tank is allowed. Minimize
the slack so that pipe is not too tight.
Recovery tank cap's tab should face
toward front of the frame.
Carburetor overflow pipe
Route between crankcase and rear arm
cross-member.
Route under the carburetor joint and
flywheel magneto leads.
COl magneto leads
Route through clamp on left side of
manifold and to right side of frame.