6) Wrest the cap by using the torque of 2.6~2.9NM.
7) After wrest the cap tightly, align the 2 half connectors and mate them together by
hand until a "click" is heared or felt.
8) When the separation of connector is necessary, use the specified wrench tool to
separate.Please make sure the wedge side of the fingers face the male connector
and push the tool down.Then separate the connector by hand. See below figure.
9) Please use sealing caps for tight sealing of unplugged PV connectors.
If using H4 connector, the operating procedure is similar as that of MC4 connector.
22