Connection procedure by MC4:
Connect the PV modules and inverter using MC4 connectors below. Connect the
positive and negative terminals from the PV modules to positive (+) terminals and
negative (-) terminals on Omniksol.
Connection Procedure:
1) Switch off the DC breaker and secure against being switched back on inadvertently.
2) Strip the cable 7 mm.
3) Insert striped cable into contact barrel and insure all conductor strands are captured
in the contact barrel.
4) Crimp contact barrel by using a hex crimping die. Put the contact barrel with striped
cable in the corresponding crimping notch and crimp the contact.
5) Insert contact cable assembly into back of the male and female connector. A "click"
should be heard or felt when the contact cable assembly is seated correctly.
21