Proper Grounding
The machine is pre-wired to be used with
a 220-volts power supply. Ensure the cord
is plugged into a grounded power outlet.
To prevent possible electrical hazards,
have a qualified electrician ensure that the
line is properly wired
Figure-1 220-Volts Outlet for CX15 & CX20
ASSEMBLY
Installing Foot Pedal & the Caster
For clarity, it is recommended that you
may want to remove the front panel on the
base of the machine. See Figure-2
Figure-2 Removing the front panel
Once you have removed the front panel,
you can begin assembling the integrated
mobile base.
Remove the hex bolt and hex nut that is
comes installed on the foot pedal bracket.
Align the holes on the caster assembly
with the holes on the bracket and flange
and insert the bolt, tighten the screws.
Now align the holes on the foot pedal with
the foot pedal bracket and secure it with
the help of the washers and screws
provided. See Figure-4
Figure-4 Installing the foot pedal and the
caster
Your mobile base should now be installed
and ready to us. You can now lower the
machine back to the ground. Once the
machine is sitting back on solid ground,
you can lock the mobile base in the place
9