Extension Wings - Craftex CX series User Manual

by lifting the foot pedal up. When you are
ready to move your machine again, it is
recommended that you use the lifting
handles (or once the table extension
wings are in place) as leverage when
operating the foot pedal so that you do not
hurt your back (the machine is very
heavy, so a strong rigid mobile base has
been provided).
Installing the Extension Wings
Remove the extension wings from the
cardboard box. Starting with either the
front or the back of the machine, take the
first extension table and line the holes of
the table bed with the holes of the
extension table. Using the hex bolts, lock
washers and flat washers provided,
finger-tighten all the holes so that the
table is secure. Do not fully tighten at this
time. See Figure-5
Figure-5 Installing the extension wings
Once you have installed both extension
wings, you can begin the process of
leveling out the tables to make sure that
they are both flush machine.
Assembly
The extension tables are equipped with
adjusting set screws that make these
adjustments very easy. See Figure-6
Figure-6 Adjusting the set screws
It is important to use a straight edge at
this time as a guide and the set screws for
leveling to make sure it is attached
properly. Position the extension wings
even with the main bed and once fully
leveled, tighten all hex bolts. See Figure-7
Figure-7 Leveling the wings using straight edge
Repeat the same procedure for the other
extension wing.
10