Table of Contents
Advertisement
After drilling the required hole, run the cable through and seal it with cable
bushings, silicone or other waterproof sealant to enclose the hole that you have
created. In some instances, it may be possible to run the cable up into the fascia of
the attic overhang. In this circumstance, the cable will be accessible in the attic for
further routing.
Installing the Inside Antenna
(Instructions are for optional Panel Antenna)
Select a location for the Inside Antenna, preferably in the center of where the signal
needs to be amplified. A minimum separation distance of 20 vertical feet (within
the null zone) or 50 horizontal feet is necessary for proper operation. If the
inside coverage is not sufficient you may need as much as 75 feet of horizontal
separation. Refer to installation diagram on pages 3 & 4.
Ceiling
Rafters
In some cases, multiple Inside Antennas may be required, for instance if you
have multiple rooms with poor signal. A signal may be split by using a splitter
(sold separately). See configuration on pages 3 & 4.
Warning: An Inside Antenna must have a separation distance from all persons
that is at least 15 inches for the Panel Antenna.
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com.
Inside
Antenna
Splitter Options:
50 ohm
Optional Wide
Band Inside
Antenna (sold
separately)
Multiple mounting
options available
(859957)
75 ohm
Mon.- Fri. Hours: 7 am to 6 pm MST.
(sold separately)
2-way
3-way
4-way
(859980)
(859981)
2
2-way
(859993)
Ceiling
Drywall
3-
3-way
(8
(859994)
8
Advertisement
Table of Contents
