Table of Contents
Advertisement
may be possible to run the cable up into the fascia of the attic
overhang . In this circumstance, the cable will be accessible in the
attic for further routing .
Installing the Inside Antenna
Find the desired location for the Inside Antenna (Panel Antenna
option shown) . Verify that the Inside Antenna and the Outside
Antenna have the necessary separation (Minimum of 20 vertical/
horizontal feet if installed with Signal Booster set at a lower
gain, for maximum gain you may need as much as 50 feet of
separation) . For optimum results the antenna should be mounted
at least 6 feet off the ground .
Inside
Antenna
Ceiling
Rafters
In some cases, multiple Inside Antennas may be required, for
instance if you have multiple rooms with poor signal . A signal may
be split by using a splitter (sold separately) . If using more than
one Inside Antenna, a separation of at least 20 feet is necessary
between Inside Antennas . See configuration on pages 3 & 4 .
Warning: An Inside Antenna must have a separation distance
from all persons that is at least 8 inches .
Splitter Options:
(sold separately)
4-way
3-way
2-way
(859981)
(859980)
(859957)
8
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.
Advertisement
Table of Contents
