Table of Contents
Advertisement
CORRECT INSTALLATION
Point antennas away from each other
Inside Panel
Antenna
Signal Booster
Figure 1
Understanding the Signal Booster Lights and
Troubleshooting
The Signal Booster is equipped with four indicator lights for each Band (700 –
Band 12,13,17/800 – Band 5/1900 – Band 2/1700/2100- Band 4). The lights will
do one of the following 3 things:
Note: Reset the Signal Booster by disconnecting and reconnecting the power
supply from the Signal Booster.
Note: All red lights must be resolved before orange lights.
1. GREEN
The indicator lights on the Signal Booster will be green if the unit is powered
up and working properly.
2. ORANGE
The Signal Booster is experiencing receiver overload. The Signal Booster has
protection circuits to prevent the disruption of cell towers. If one or more of
the lights are orange, this indicates that the Signal Booster has automatically
reduced the gain due to close proximity to a cell tower. To view how much the
gain has been reduced, turn the knob down until the light turns green. This
is the Actual Gain that the Signal Booster is operating on. Since the Signal
Booster adjusts gain automatically, there is no need to turn the gain down. If
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com.
Never point antennas toward each other
Outdoor
Antenna
Signal Booster
Figure 2
Mon.- Fri. Hours: 7 am to 6 pm MST.
INCORRECT INSTALLATION
Outdoor
Antenna
Inside Panel
Antenna
10
Advertisement
Table of Contents
