Installing The Inside Panel Antenna(S); Installing The Signal Booster - Wilson Electronics PRO Series Installation Manual

Installing the Inside Panel Antenna(s)

Select a location for the inside antenna, preferably in the center of where the signal
needs to be amplified . A minimum separation distance of 20 vertical feet and or
50 horizontal feet between the inside and outside antenna(s) may be necessary
in order to achieve full booster gain and therefore maximum indoor coverage . If
the amplifier can not be set to maximum gain as explained on page 10, you may
need as much as 75 feet of horizontal separation, or mechanical isolation, between
inside and outside antennas . Refer to installation diagram on pages 3 & 4 .
Ceiling
Rafters
Some installations requiring signal improvement in far areas of larger homes or
structures may require multiple inside antennas and splitter(s) . For example if
signal is improved in most areas of a structure, but yet there is weak signal In
another area, the signal from the booster can be split to two or more separate
indoor antennas by using a splitter (sold separately) . Refer to the configuration
on pages 3 & 4 .
Additional Inside Panel
Antenna
(311155-0630, sold separately)
Multiple mounting options
available
For additional antenna options
see pages 13 & 14

Installing the Signal Booster

Select a location for the signal booster which is away from excessive heat, direct
sunlight, moisture and is not subject to high temperatures . Do not place the signal
booster in an air-tight enclosure . Recommended installation locations for in-building
signal boosters are in a closet or on a shelf where power is available . Attic installations
may expose the booster to high heat .
7
Contact Wilson Electronics Customer Support Team with any questions at 866-839-9361
or email: tech@wilsonelectronics.com.
Inside
Antenna
Splitter Options:
(859993)
Mon.- Fri. Hours: 7 am to 6 pm MST.
2-way
3-way
(859994)
Ceiling
Drywall
4-way
(859106)