Table of Contents
Advertisement
Signal Booster Specifications
Model Number
Antenna connectors
Antenna Impedance
Dimensions
Weight
Frequency
3
Power output for single cell phone (dBm)
Noise Figure (typical downlink/uplink)
Isolation
Power Requirements
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory reprogramming or
disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase coverage of authorized frequency bands
only. If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected. If a detected signal is too high in a frequency band, or if
the Signal Booster detects an oscillation, the Signal Booster will automatically turns the power off on that band. For a detected oscillation, after a minimum of 1
minute, the Signal Booster will automatically resume normal operation. After 4 (four) such automatic restarts, any problematic bands are permanently shut off until
the Signal Booster has been manually restarted by momentarily removing power from the Signal Booster. Noise power, gain, and linearity are maintained by the
Signal Boosters microprocessor, that determines necessary attenuation.
3301 East Deseret Drive, St. George, UT 84790
For additional Technical Support visit www.WilsonElectronics.com
Phone: 866-294-1660
www.twitter.com/WilsonCellular
698-746 MHz / 746-787 MHz / 824-894 MHz / 1850-1990 MHz / 1710-2155 MHz
700 A MHz
700 V MHz
Uplink
29.1
Downlink
23.7
Wilson Electronics, LLC
or email at: tech@wilsonelectronics.com
Local: 435-673-5021
www.facebook.com/WilsonCellular
AG Pro Quint
273470
N-Female
50 Ohms
8.875 x 6.0 x 1.5 inch (22.5 x 15.2 x 3.8 cm)
2.8 lbs (1.270 kg)
800 MHz
1900 MHz
28.4
29.1
29.1
23.7
22.7
22.8
5 dB nominal
> 90 dB
110-240 V AC, 50-60 Hz, 20 W
Fax: 435-656-2432
111245_AGProQuint_Rev01_08.02.13
1700/2100 MHz
27.1
22.8
Advertisement
Table of Contents
