User Presets - Extron electronics RGB-DVI 300 User Manual

User Presets

User Presets
aspect ratio settings. When
page 20) are set, the current values for
Vertical Centering
be saved on one input resolution and recalled for a different input resolution.
To save user presets, navigate to the
user preset
Figure 18.
When a preset has been saved, it can be recalled or cleared using the
Select a user preset (
NOTE: The brackets
(
Recall
yet been saved, an
Comparison of User Presets and Input Presets
User Presets
Contrast
Brightness
Detail
Table 4. Comparison of User Presets and Input Presets.
An additional 16 presets (input presets) are available through SIS commands only. Input presets
save picture control settings (the same values saved by user presets) and input configuration
values (input type, total pixels, horizontal and vertical starts, horizontal and vertical active areas
and phase). The exact settings of a source are saved and can be recalled each time that source
is applied. Input presets are valid only for the source and resolution that was active
when the preset was saved.
are a user-defined set of picture control settings for up to three commonly used
Picture Controls
Contrast
, and
Horizontal
User Presets > Save
1 , 2 , or 3 and then press Enter
User Presets Menu
1 , 2 , or 3 ) to be recalled or cleared and then press
around the current selection are visible only when that function
<>
, , or ) has been activated. If you try to recall a user preset that has not
Save Clear
Invalid Preset
H position
V position
H size
V size
Zoom
RGB DVI 300 and RGB HDMI 300 (A) • Configuration
(see page 18) and Input Configuration
, ,
Brightness Detail
and can be saved. User presets can
Vertical Size
submenu. Use the
to save. Press Menu to exit.
Recall
message appears on the on-screen display.
Input Presets
Input type H start
Total pixel V start
Contrast H active
Brightness V active
Detail Phase
(see
, and
Horizontal
{ knob to select
or options.
Clear
Enter .
H position
V position
H size
V size
Zoom
19