Extron electronics RGB-DVI 300 User Manual page 13

Audio input (only in RGB-HDMI 300 A model) — The 3.5 mm TRS audio input accepts
3
unbalanced stereo signals. The audio signal is embedded in the HDMI output signal.
4 Digital signal output — All models output digital signals. The RGB-DVI 300 outputs a
DVI-D signal through a female DVI-I connector; the RGB-HDMI 300 and RGB-HDMI 300 A
output an HDMI signal through a female HDMI connector.
Use the female DVI-I connector (RGB-DVI 300) or the female HDMI connector (RGB-HDMI
300 and RGB-HDMI 300 A) to pass the output signal to the display device.
DVI-D OUTPUT
Figure 5.
Digital Output Sockets
NOTE: Although the RGB-DVI 300 has a rear panel DVI-I connector, the output signal is
DVI-D (digital only).
For the RGB-HDMI 300, secure the HDMI cable with the LockIt HDMI lacing bracket
provided. Connect a HDMI source device to the HDMI input connector on the
RGB-HDMI 300.
To secure each cable to the unit, attach an Extron LockIt bracket to the unit and secure it to
the cable with a zip tie as follows:
1. Plug the HDMI cable into the panel connection
(see figure 6, 1 ).
2. Loosen the HDMI connection mounting screw
from the panel enough to allow the LockIt
lacing bracket to be placed over it (
screw does not have to be removed.
3. Place the LockIt lacing bracket on the screw
and against the HDMI connector (
tighten the screw to secure the bracket (
4. Loosely place the included tie wrap around
the HDMI connector and the LockIt lacing
bracket as shown ( 5
5.
While holding the connector securely against
the lacing bracket, tighten the tie wrap, then
remove any excess length.
Complete details on LockIt installation are
available in the LockIt HDMI Cable Lacing Bracket
Installation Guide at www.extron.com.
HDMI OUTPUT
). The
2
), then
3
4 ).
4 4
).
Figure 6.
RGB DVI 300 and RGB HDMI 300 (A) • Cabling
3 3
2 2
1 1
3
5 5
Securing HDMI cable
with LockIt Lacing
Bracket
5