Extron electronics RGB-DVI 300 User Manual page 45

Command
User Presets
Save User Preset
Recall User Preset
KEYS:
X1*
= User Preset (1 to 3)
Save command saves the current settings to one of three user presets. The final character of the command is a comma (,).
Recall command recalls the user preset values for the current input. The final character of the command is a period (.).
Input Presets
Save Input Preset
Recall Input Preset
KEYS:
X1(
= Input Preset (1 to 16)
Save command saves the current settings to one of 16 user presets. The final character of the command is a comma (,).
Recall command recalls the user preset values for the current input. The final character of the command is a period (.).
The parameters saved in user presets and input presets are:
User Presets
Contrast
Brightness
Detail
Auto Memories
Enable Auto Memory
Disable Auto Memory
View Auto Memory Status
KEYS:
X@
= Auto Memory Status (1= enabled; 2= disabled).
When Auto Memory is enabled, previous settings for incoming settings are automatically recalled.
When Auto Memory is disabled, the input lookup table values are used to configure the input.
Test Pattern
Set Test Pattern
View Test Pattern
KEYS:
X2)
= Test Pattern.
For a list, see see
ASCII command
(host to device)
X1*
1* ,
X1*
1* .
X1(
2* ,
X1(
2* .
H position
V position
H size
V size
Zoom
E }
1AMEM
E }
2AMEM
E }
AMEM
E X2) }
TEST
E }
TEST
test patterns on page 31.
Response
(device to host)
X1*]
1Spr
X1*]
1Rpr
X1(]
2Spr
X1(]
2Rpr
Input Presets
Input type H start
Total pixel V start
Contrast H active
Brightness V active
Detail Phase
]
Amem1
]
Amem2
X@]
Amem
X2)]
Test
X2)]
Test
RGB DVI 300 and RGB HDMI 300 (A) • SIS Commands
Additional description
H position
V position
H size
V size
Zoom
37