Operation
8.9 Faults
Record the decommissioning steps. This log will be useful upon recommissioning.
8.8
Re-commissioning the machine
When you re-commission the machine, proceed as follows:
● Study the record made when the machine was decommissioned, and reverse the measures
● Perform the measures listed in the "Commissioning" section.
8.9
Faults
8.9.1
Inspections in the event of faults
Natural disasters or unusual operating conditions, such as overloading or short circuit, are
faults that overload the machine electrically or mechanically.
Immediately perform an inspection after such faults.
Correct the cause of the fault as described in the respective remedial measures section. Repair
any damage to the machine.
8.9.2
Electrical faults at force-ventilated motors
Note
When operating the machine with a converter, also refer to the operating instructions of the
frequency converter if electrical faults occur.
82
that were taken for conservation and storage.
Operating Instructions 05/2012 A5E03986435A AA
SIMOTICS M-1PH8