For Use In Hazardous Areas In Zone 22 - Siemens SIMOTICS M-1PH8 Operating Instructions & Installation Instructions

Safety notes

2.5 For use in hazardous areas in Zone 22

Noise emissions
During operation, the machine's noise emission levels can exceed those permitted at the
work place. which can cause hearing damage.
Take steps to reduce noise, such as introducing covers and protective insulation or adopting
hearing protection measures, so that the machine can be operated safely within your system.
2.5 For use in hazardous areas in Zone 22
Electrical systems in hazardous areas must be assembled, installed, and operated by the
responsible persons in accordance with the applicable rules and regulations.
Note
The basic requirements relating to electrical systems and their operation in hazardous areas
are described, for instance, in Directives 94/9/EG and 1999/92/EG as well as in the standard
IEC / EN 60079-14.
Ignition hazards
The assessment of operating risks and local operating conditions and the necessary
monitoring methods must be clarified and made binding by the system operator, coordinated
with the responsible supervisory authority. It is mandatory that the necessary measures are
complied with. The machine manufacturer cannot offer any generally applicable
recommendations in this case. Please observe the information in these Operating Instructions.
Note
The basic requirements relating to the assessment of ignition hazards arising from electrical
systems and their operation in hazardous areas are given, for instance, in Directives 94/9/
EG and 1999/92/EG as well as in the series of standards IEC / EN 60079.
16
WARNING
Operating Instructions 05/2012 A5E03986435A AA
SIMOTICS M-1PH8