ABB Endura APA592 Operating Instruction page 67

Endura APA592
pH / Redox (ORP) transmitter
Device Setup Parameters
Parameter
Device Info
Device Type
Device Serial No.
Software Version
Hardware Version
HART Tag
HART Descriptor
Long Tag
Write Protection
HW write prot.
SW write prot.
OI/APA592–EN Rev. E
Description
The type of device, for example APA592–PH (read-only).
The device-specific serial number (read-only).
The device's software version number (read-only).
The device's hardware version number (read-only).
A configurable HART tag. Default tag is APA592PH.
Use to specify a short HART description for the device (entered from the
alphanumeric character set).
Use to specify a longer HART description for the device (entered from the
alphanumeric character set, maximum 32 characters).
Displays hardware / software write protection status.
Note. Configurations can be protected by enabling the configuration
DIP-switch – see Section 6.2, page 46.
Displays the current state of the Hardware Write Protection switch
(configuration DIP-switch) – Off / On.
Turns the software Write Protection Off / On.
Note. Software Write Protection cannot be modified when hardware write
protection is enabled through the DIP switch – see Section 6.2, page 46.
7 Operator Pages and Menus
Tx
Type
65