wtw inoLab Oxi Level 2 Operating Manual page 41

Setting the
data transmission
interval
The interval is set to OFF in the factory.
To start the data transmission, set up an interval (5 s, 10 s,
30 s, 1 min, 5 min, 10 min, 15 min, 30 min, 60 min):
1 Press and hold down the
a
2 Press the
Int 2 appears on the display.
u d
3 Press
between storage processes.
4 Confirm with
The instrument changes automatically to the
measuring mode.
Note
If the AutoStore function is active, the data transmission is
performed according to the setting of the storage interval
(Int1). Set the storage interval (Int 1) to OFF to activate the
data transmission interval (Int 2).
Note
You can also set the data transmission interval (Int 2) in the
Configuration menu (see page 115).
g
key.
key.
to set up the required time interval
g
.
Operation
111