Outputting to
printer/interface
Note
If you want to find a specific parameter (e.g. date), proceed
as follows:
1 Select the parameter (e.g. date) by pressing
u
2 Press
or
date appears on the display. After approx. 2 s, the
temperature of the displayed measured value
appears.
r
1 Press the
on the display.
g
2 Press the
Sto CAL appears on the display. The calibration
protocol is transmitted to the printer/interface.
Following the calibration protocol, the complete
contents of the storage is printed.
Note
You can the cancel the transmission by pressing
d
repeatedly until the required
key repeatedly until Sto SEr appears
key.
Operation
g
.
m
g
or
.
107