wtw inoLab Oxi Level 2 Operating Manual page 15

Connecting the
plug-in power
supply
The plug-in power supply supplies the dissolved oxygen
meter with low voltage (7.5 V ... 12 V DC).
Warning
The line voltage on site must lie within the input voltage
range of the original plug-in power supply unit (see chapter
7 T D
ECHNICAL ATA
Caution
Use original plug-in power supplies only
(see chapter 7 T
ECHNICAL DATA
1 Insert the plug (1) into the socket (2) of the meter.
2 Connect the original WTW plug-in power supply (3) to
an easily accessible mains socket.
Note
You can also perform measurements without a plug-in
power supply. However, the functions of the integrated
printer and a connected stirrer can only be used when the
plug-in power supply is connected.
).
).
3
Commissioning
2
1
85