Table of Contents
Advertisement
GETTING STARTED
3.
Verify that the SIM card fits into the holder properly and replace the cover.
Removing a SIM Card
To remove a SIM card:
Warning:
If the device is connected to a computer or power supply, disconnect it. Inserting or removing a SIM
card with the device powered may harm the SIM card and the device.
1.
Remove the SIM cover from the back of the device. If you have trouble sliding the SIM cover, use a flat-
blade screwdriver in the slot on the SIM cover to slide it out.
2.
Slide the SIM card out.
3.
Replace the SIM cover.
Turning the Device On or Off
This USB-powered device does not have a power button. Connect the device to a computer's USB port to turn it
on.
After plugging in the device, allow 15 seconds to initialize before using.
Disconnecting it or shutting off the computer, turns it off. For best practices, follow the steps in Powering Off or
Rebooting a Device.
Note:
When reconnecting the device, use the same USB port that you used when installing drivers. Otherwise,
you may need to re-install the driver.
Powering Off or Rebooting a Device
To power off your device:
1.
Suspend dial-up network.
2.
Suspend ModemQuery.
3.
Wait for Steps 1-2 to complete.
14
®
QuickCarrier
USB-D MTD-MAT1 User Guide
Advertisement
Table of Contents
