Table of Contents
Advertisement
USING LINUX
Step 3. Use the following command line to start pppd:
pppd debug call MAT1-peer
This command line enables logging of debug information and tells pppd to use the peer file referenced by the call
option. After 20-30 seconds, type ifconfig and check whether a ppp interface is listed. If it is not, then check syslog
for pppd and chat events. Normally pppd/chat logging is written to /var/log/syslog (could vary depending on syslog
configuration).
22
®
QuickCarrier
USB-D MTD-MAT1 User Guide
Advertisement
Table of Contents
Need help?
Do you have a question about the QuickCarrier USB-D and is the answer not in the manual?