Chapter 3 – Getting Started
Getting Started Overview
To use the MTD, do the following:
1.
Insert the SIM Card. Refer to Installing a SIM Card.
2.
If you have not done so, install any drivers. Refer to the separate driver installation guide for your device.
3.
Power up the device. Refer to Turning the Device On or Off.
4.
Install terminal software that can communicate with the device, such as HyperTerminal, Tera Term,
Kermit, or Putty.
5.
Activate the device.
Installing a SIM Card
To install a SIM Card:
Warning:
If the device is connected to a computer or power supply, disconnect it. Inserting or removing a SIM
card with the device powered may harm the SIM card and the device.
1.
Remove the SIM cover from the back of the device. If you have trouble sliding the SIM cover, use a flat-
blade screwdriver in the slot on the SIM cover to slide it out.
2.
Insert the SIM card into the card holder with the gold contact side facing down as shown.
®
QuickCarrier
USB-D MTD-MAT1 User Guide
GETTING STARTED
13