Figure 11 G-240W-C Ont With Fiber Cover; Table 5 G-240W-C Indoor Ont Physical Connections - Nokia 7368 ISAM ONT G-240W-C Product Manual

7368 ISAM ONT G-240W-C Product Guide
Figure 11
Table
Table 5
Note
(1)
Issue: 01
R05.05.01 | December 2016 | 3FE 46690 AAAA TCZZA | Edition 01
G-240W-C ONT with fiber cover
5 describes the physical connections for G-240W-C indoor ONTs.
G-240W-C indoor ONT physical connections
(1)
Connection Description
POTS ports This connection is provided through RJ-11 ports. Up to two POTS connections are
supported.The POTS ports support voice services.
Ethernet ports This connection is provided through Ethernet RJ-45 connectors. Up to four 10/100/1000
Base-T Ethernet interfaces are supported.The Ethernet ports can support both data and
in-band video services on all four interfaces.
USB ports This connection is provided through 2 USB ports. The ONT supports external USB hard
drives that can be made accessible to all LAN devices.
WPS buttons The Wi-Fi Protected Setup buttons are labeled WPS2.4G and WPS5G. These buttons
enable and disable WLAN data encryption.
WLAN button Wi-Fi service is compliant with IEEE 802.11 standards and is enabled and disabled using
the WLAN button.
Reset button Pressing the Reset button for less than 10 seconds reboots the ONT; pressing the Reset
button for 10 seconds resets the ONT to the factory defaults, except for the LOID and SLID.
Power input This connection is provided through the power connector. A power cable fitted with a barrel
connector is used to make the connection.
On/Off button This button turns the ONT on or off.
Fiber optic port This port provides the connection for the fiber optic cable.
The primary path for the earth ground for these ONTs is provided by the 12V Return signal in the power
connector.
TEL1 TEL2
LAN1 LAN2 LAN3 LAN4 USB1
Fiber optic connector
(covered)
Edition 01
G-240W-C unit data sheet
USB2 POWER ON/OFF
WPS2.4G WLAN
WPS5G RESET
25274
43