Sfu Mode Configuration; Switch From Default Hgu Mode To Sfu Mode - Nokia 7368 ISAM ONT G-240W-C Product Manual

Configure a G-240W-C indoor ONT
(2 of 2)
2
3
4

7.3 SFU mode configuration

HGU is the default mode for the G-240W-C ONT, but you can use SFU mode to view
device status information, change the password, authenticate the LOID, and change
the SLID.
7.3.1
To switch from the default HGU mode to using SFU mode, use the procedure below.
Procedure 51
1
2
3
4
130
R05.05.01 | December 2016 | 3FE 46690 AAAA TCZZA | Edition 01
Field
DNS Response Time
Configure the test times if desired.
Click Refresh to update the data.
STOP. This procedure is complete.

Switch from default HGU mode to SFU mode

Switching to SFU mode
Power up the G-240W-C ONT.
Change the Operator ID (OPID) to XXXX to enable the ONT to switch to SFU mode, as
described in "Modifying the operator
Reboot the ONT.
STOP. This procedure is complete.
7368 ISAM ONT G-240W-C Product Guide
Description
This test is used to determine the lowest round-trip time in milliseconds by
sending a request to the target DNS server
Click DNS Response Test to specify the time for the test
The default is weekly, performed at idle to a public server
ID".
Edition 01 Issue: 01