Nokia 7368 ISAM ONT G-240W-C Product Manual page 60

Install a G-240W-C indoor ONT
7
8
9
10
11
12
13
14
15
60
R05.05.01 | December 2016 | 3FE 46690 AAAA TCZZA | Edition 01
Note — Fiber cable preparation varies depending on the type and size
of the inside or outside plant fiber cable being spliced to the SC/APC fiber
optic pigtail cable.
Install the power supply according to manufacturer specifications.
Note — Observe the following:
•
Units must be powered by a Listed or CE approved and marked
limited power source power supply with a minimum output rate of
12VDC, 3A.
Connect the power cable to the power connector.
Power up the ONT unit by using the power switch.
If used, enable the Wi-Fi service.
i Locate the WLAN button on the ONT; see Figure
ii Press the WLAN button to change the status of the Wi-Fi service.
Verify the ONT LEDs, voltage status, and optical signal levels; see the 7368 Hardware and
Cabling Installation Guide.
Activate and test the services; see the 7368 Hardware and Cabling Installation Guide.
If used, configure the SLID; see the 7368 ISAM ONT Configuration, Management, and
Troubleshooting Guide.
If necessary, reset the ONT.
i Locate the Reset button on a G-240W-C indoor ONT as shown in Figure 15.
ii Insert the end of a straightened paper clip or other narrow object into the hole in the
Reset button to reset the ONT.
STOP. This procedure is complete.
7368 ISAM ONT G-240W-C Product Guide
Edition 01
15 for location of the WLAN button.
Issue: 01