Safety Instructions And Measures - Samson TROVIS 6600 Mounting And Operating Instructions

Safety instructions and measures

1 Safety instructions and measures
Intended use
The TROVIS 6611-2 Control and Automation Unit is freely programmable and allows autono-
mous operation and management of six I/O modules. It has an integrated color touch screen
for visualization.
To allow the control and automation unit to access the I/O modules in the required manner,
the I/O modules must be mapped logically as a project in the unit. For this purpose,
SAMSON provides ready-made applications. Alternatively, a project can be programmed
using the SAMSON graphical project management tool (logic circuits, menu navigation,
visualization and start-up).
The control and automation unit as well as the I/O modules are designed to operate under
exactly defined conditions (e.g. power supply, ambient conditions). Therefore, operators must
ensure that the unit is only used in applications where the operating conditions correspond to
the technical data. In case operators intend to use the unit in other applications or conditions
than specified, contact SAMSON.
SAMSON does not assume any liability for damage resulting from the failure to use the de-
vice for its intended purpose or for damage caused by external forces or any other external
factors.
Î Refer to the technical data for limits and fields of application as well as possible uses. See
section 3.3.
The operator is responsible for the physical and logical project management, if not agreed
otherwise.
Reasonably foreseeable misuse
The control and automation unit is not suitable for the following applications:
− Use outside the limits defined during sizing and by the technical data
Furthermore, the following activities do not comply with the intended use:
− Use of non-original spare parts
− Performing service and repair work not described in these instructions
EB 6611-2 EN 5