Remote Management - TP-Link TL-MR6400 User Manual

By default, the radio button
Web-Based Utility is selected. If you want to allow PCs with specific MAC Addresses to access
the Setup page of the router's Web-Based Utility locally, from inside the network, click the radio
button Only the PCs listed can browse the built-in web pages to perform Administrator
and then enter each MAC Address in a separate field. The format for the MAC Address is
XX-XX-XX-XX-XX-XX (X is any hexadecimal digit). Only the PCs with the MAC address listed
can use the password to browse the built-in web pages to perform Administrator tasks and all
the others will be blocked.
After click Add, your PC's MAC Address will be placed in the Control List above.
Click Save to make the settings effective.

Note:
If your PC is blocked and you want to access the router again, press and hold down the
WPS/RESET button on the rear panel of the router until the Power LED starts flashing to reset the
router's factory defaults in the router's web management page.

4.11.3 Remote Management

Go to Security Remote
→
This feature allows you to manage your Router from a remote location via the internet.
Web Management Port

port 80. This Router's default remote management web port number is 80. For greater
security, you can change the remote management web port to a custom port by entering
All the PCs on the LAN are allowed to access the Router's
Management, you can configure the Remote Management function.
- Web browser access normally uses the standard HTTP service
-51-
TL-MR6400 User Guide
tasks,