Time Settings - TP-Link TL-MR6400 User Manual

SNMP Agent - Choose

through SNMPv1/v2 agent with MIB-II. Choose
SysContact - The textual identification of the contact person for this managed node.

SysName - An administratively-assigned name for this managed node.

SysLocation - The physical location of this node.


Note:
Specifying one of these values via the Device's web management page makes the corresponding
object read-only. If there isn't such a config setting, then the write request will succeed (assuming
suitable access control settings), but the new value would be forgotten the next time the agent
was restarted.
Get Community - Enter the community name that allows Read-Only access to this device's

SNMP information. The community name can be considered a group password. The
default setting is public.
Get Source - Get source defines the IP address or subnet for management systems that

can read information from this 'get' community device.
Set Community - Enter the community name that allows Read/Write access to this device's

SNMP information. The community name can be considered a group password. The
default setting is private.
Set Source - Set source defines the IP address or subnet for management systems that

can control this 'set' community device.

Note:
A restricted source can be a specific IP address (e.g. 10.10.10.1), or a subnet - represented as
IP/BITS (e.g. 10.10.10.0/24). If an IP Address of 0.0.0.0 is specified, the agent will accept all
requests under the corresponding community name.
Click Save to make the settings effective.

5.18.2 Time Settings

Go to System Tools
→
screen.
Enable to open this function if you want to have remote control
Time Setting, and then you can configure the time on the following
-110-
TL-MR6400 User Guide
Disable to close this function.