Table of Contents
Advertisement
MBT-5000 L-Band Up/Down Converter System
Front Panel Operation
SNMP: Traps
SNMP Trap IP Address:
IP1 IP2 Version
Use the ◄ ► arrow keys to select IP1, IP2, or Version, and then press ENTER.
SNMP Trap IP Address: IP1 or IP2
Trap IP #1:
000.000.000.000(◄ ► ▲ ▼ E)
Trap IP #2:
000.000.000.000(◄ ► ▲ ▼ E)
To edit the Trap Destination IP Addresses: First, use the ◄ ► arrow keys to select the
digit to edit, and then use the ▼▲ arrow keys to edit the value of that digit. Press
ENTER when done.
SNMP Trap IP Address: Version
Trap Version:
SNMPv1
Use the ◄ ► arrow keys to select the trap version – SNMPv1 or SNMPv2 – and then
press ENTER.
5.2.2.2
CONFIG: FltRec (Fault Recovery) Menu
Fault Recovery: Manual
Automatic
Use the ◄ ► arrow keys to select Manual or Automatic, and then press ENTER.
5.2.2.3
CONFIG: ConvA or ConvB (Converter 'A' or Converter 'B') Menus
Converter X
Mute/Freq Attenuation
Where 'X' is the selected converter – Converter (Side) A or Converter (Side) B – use the arrow
keys to select Mute/Freq or Attenuation, and then press ENTER.
If both Trap IP Addresses are 000.000.000.000, it means Traps are
.
disabled
SNMPv2
(◄ ► E)
(◄ ► E)
5–9
MN-MBT5000
Revision 4
Advertisement
Table of Contents
Need help?
Do you have a question about the MBT-5000 and is the answer not in the manual?
Questions and answers